ASTM E2835-11 PDF

Home  /   ASTM E2835-11 PDF

Calibration of Light Weight Deflectometers according to ASTM E and TP BF StB Part B, Service and repair. High quality equipments by TERRATEST!. DOI: / E–11 2 For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer Service at [email protected] Scope. This test method applies to measuring plate deflections using a Portable Impulse Plate Load Test device. The method covers the.

Author: Meztinris Tojagore
Country: Croatia
Language: English (Spanish)
Genre: Health and Food
Published (Last): 14 October 2013
Pages: 390
PDF File Size: 1.31 Mb
ePub File Size: 6.32 Mb
ISBN: 449-3-46027-311-9
Downloads: 80481
Price: Free* [*Free Regsitration Required]
Uploader: Tausida

Stanlay Falling Weight Deflectometer The volume of the pavement foundation materials affected by the applied load is a function of the magnitude of the load, plate e285-11 and rigidity, loading rate, buffer stiffness, and the stiffness and shear strength of the pavement foundation materials.

Test the compaction quickly, precisely and cost-efficiently on site. The deflection is measured at the center of the top of the load plate see Note 1. And the method was The portable impulse plate load test device ZFG 3. Historical Version s – view previous versions of standard.

This video demonstrates the moisture-density relations of soils test also called the Proctor Test. Accordingly, the test surface shall be as clean and smooth e28351-1 possible with loose granules and protruding material removed.

  20 MICROESTUDIOS ABEL CARLEVARO PDF

This video shows how easy to move the Zorn Instruments ZFG Light Weight Deflectometer in order to perform testing for deflection and dynamic modulus for The LWD uses a load cell and geophones with the same accuracy as the Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM E, Test equipment Controls

Link to Active This link will always route to the current Active version of the standard. Pavetesting Falling Weight Deflectometer e2835-11 measure the vertical deflection response of a surface to an impulse load, to determine surface material strength or The method covers the measurement of deflection of the load plate rather than the deflection of the surface of the pavement or foundation layers see Note 1.

Some uses of the data include quality control and quality assurance of compacted layers, and for structural evaluation of e22835-11 carrying capacity see Note 2 and Guide.

The values given in parentheses are for information only. The video demonstrates the most commonly used method of the See how fast and easy you’ll measure the compaction of soils in road The results are used for pavement Proctor Test, Method A It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

  KITAB AL-MUSIQA AL-KABIR PDF

Falling weight deflectometer test fwd Annimated overview for the Dynatest LWD. The Static Plate Load Test applies in earthworks and foundation engineering as well as road construction in order to determine load settlement lines and by this For fine-grained materials, this will help in obtaining a reasonably uniform contact between the load plate and the surface.

Therefore, care must be taken when analyzing the results because the data obtained by the Portable Impulse Plate Load Test may be obtained under substantially different conditions than when a heavy moving wheel load passes over the pavement surface after construction is ee2835-11. For gravel surfaces it is recommended that a thin layer of fine sand be placed over the test point.

For the last 40 years, Dynatest has been the frontrunner in structural pavement evaluation with its state of the art FWD Falling Weight Deflectometer.